2/19/2023 0 Comments Colormunki display vs spyder 3 proOut of curiosity I went into the OSD control panel to see what the settings had been adjusted to and was surprised to see that they hadn't changed at all from when I'd performed the factory default setting. The 'factory default' setting had been rather heavily magenta/pink biased and also appeared over bright. I was able to perform Datacolor's 'switch' procedure enabling me to see 'before' and 'after' views. Once the re-profiling was complete, the 'look' of things was of course quite different. Spyder said I was to reset my parameters to factory default before calibration, which I did. I have a few questions which maybe you or other kind souls on here might be able to answer. I've successfully re-installed Spyder3Pro and have used it to re-profile my monitor. I wonder if it's worth removing the programme from my computer and reinstalling it (I have all my stuff backed up to two external hard drives)?īefore I rush out and buy a new Spyder5 Pro (£113.67 post paid on Amazon) I wonder if anyone has anything to add here that might enable me to squeeze a few more uses out of my existing device? I've emailed Datacolor and sent them a screen print of the Activation page (where the 'Next' button led nowhere) but so far I've heard nothing in reply. I have actually used it in the past with my current OS, so I know I have the correct driver installed for 8.1 圆4bit. I've located a 2014 email from Datacolor in which they sent me the license code for my 'activated product' and advised me to keep the info in a safe place in case I ever wanted to reinstall the software on my computer.Ī few months ago I had occasion to reinstall my Windows OS (8.1 圆4bit) and this is the first time I've attempted to use my Spyder since then. I am fully aware that Datacolor no longer supports this earlier version of Spyder, but I was under the impression that, assuming one has a legally purchased copy of the software (I have) and access to the license code (yes to that too) it should be possible to proceed with its use. This I did, but when the screen headed 'Datacolor Spyder3Pro Activation' appeared, it didn't respond when I clicked the 'Next' button. monitor turned on for a good half hour so it's nice and warm, no direct light falling on the screen, plug in Spyder3 Pro before launching programme. It's been a while since I calibrated/re-profiled my PC monitor, so I thought it was about time to revisit the process.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |